{"title":"NG6 (D03) Pressure Reducing Valves","description":"\u003cp\u003eNG6 (D03) pressure reducing valves are sandwich plates that hold one valve station at a constant, lower pressure than the rest of the system. They mount between the directional control valve and the sub-plate, with the NG6 interface to ISO 4401-03, CETOP 3 and NFPA D03, so one pump can supply stations that need different pressures.\u003c\/p\u003e\u003cp\u003eThe version decides which line is reduced. Version P reduces the supply pressure for the whole station, so both actuator lines see the lower pressure. Versions A and B reduce the pressure in one actuator line only, for example to limit the clamping force of a cylinder in one direction while it retracts at full pressure.\u003c\/p\u003e\u003cp\u003eChoose a setting range in which the required pressure falls comfortably, since a smaller range gives finer adjustment, and check the maximum inlet pressure and the flow against the circuit. A reducing valve holds a set pressure; to protect a line against overpressure, use a pressure relief valve. Every sandwich plate adds height to the stack, so the mounting screws of the directional valve must be longer by the clamp length of each plate.\u003c\/p\u003e","products":[],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0572\/1787\/6152\/collections\/h226j_v3.jpg?v=1793152998","url":"https:\/\/tameson.es\/collections\/ng6-d03-pressure-reducing-valves.oembed","provider":"Tameson.com","version":"1.0","type":"link"}